Spakemi pH Plus 1kg for hot tubs

Delphin pH Plus Granular (powder), 1 kg

You use pH Plus to keep your bathing water in balance. It is important that you measure the pH value at regular intervals - preferably at least once a week.
If the water has a pH value below 7.0, we recommend using pH Plus Granular to raise the pH value.

Instructions for use Delphin pH Plus

The pH value is measured with a pool tester/test strips. At pH 7.0-7.4 the water feels nice and comfortable when bathing.
If the pH is below 6.9, add Plus Granular.

Carefully sprinkle the amount of granules to be added into the bath water while the massage pump is on.
After about 3 minutes, take another measurement of the pH value.
Repeat the treatment if necessary by adding another dose of pH Up until the pH is between 7.0 and 7.4.
If you use soft water, such as surface water, it may be necessary to adjust the alkalinity of the bath water with SpaCare Alka Up or SpaCare Calcium Up.

Recommended values

You should therefore pay close attention to the dosage and also regularly check and adjust the bromine, pH and alkali levels to the recommended values:
Bromine 2,0-4,0 mg/l;
pH 7.0-7.4;
Alkalinity 80-120 mg/l.

Maintenance

You change the bathing water regularly and at the same time you clean the spa. You should use Delphin Spa Pipe Cleaner to clean the built-in pipe system. You do this 3-4 times a year. After cleaning, you take the opportunity to change the filters or clean them thoroughly. After this work, it is time to fill up with new bath water that you shock treat with Oxi Booster or Spa Shock.

Maintenance procedures

For more spa care advice, see if you click here.